3.4 swap wiring

[ekj]

I have a 3.4 motor 5 speed ecu harness and every thing els from a t100 I bought for a swap and am parting the rest out . Does any one know how to do the wiring on this swap? It will be going in to a 94 pickup! Thanks for any help!!

[RedRunnertc]

thefatkid

[ekj]

I'm pretty sure I had sent him a pm a wile back but never heard back?

[RedRunnertc]

I think he's been kinda busy lately, give him a chance to reply ...

There is a whole subforum on www.yotatech.com devoted to the 3.4 swap - be sure to research there too

[mrdoug]

If you're converting from a 3.0 to a 3.4, I've read that it really isn't that bad. Go find the FSM's for both trucks and start studying the wiring diagrams.

[thefatkid]

I know how to wire those. What are you asking though?

FYI it takes me 3-4hours of solid wiring after I have sketched the harness.

[ekj]

What would you charge me to help me wire the plugs up? I can do the batt and most every thing els it's just repining the plugs and the few splices that have to be made that i'm hung up on. Also thanks in advance for any help!!

[thefatkid]

Do you already have the engine in place? Do you have the ECU and 3.4 harness part numbers (sticker on the harness near the ECU plugs)? Part number looks like 89661-xxxxx

[ekj]

I don't have it in yet .It will be a few before I do. I just bought a wreaked t100 so I should have the numbers. I wanted to make sure I could get the wiring done before I pulled my motor out. My number is 7202261190. You can call me if you like so we can talk about it some more.

[ekj]

I got my swap done! Brian " thefatkid" was a huge help! I Can't Say Enough Good Things About him! He does grate work!!:D