PDA

View Full Version : Stock Stereo


hakester
08-16-2005, 06:07 AM
I just replaced my Stock stereo, after the install I was looking for my new Cd and realized I left it in the stocker, Any Idea how to get it out? taking the new one out is not an option. If I new which pins on the back are power and ground I could probally get it.

bb609
08-16-2005, 06:33 AM
Can you reach the plug with a test lamp? Shouldn't be too hard to find the hot lead.

boylem002
08-16-2005, 09:20 AM
read the pinout diagram on the adapter plug (assuming you used one), if you threw it away, the top right pin on the stereo is the yellow wire, next to the left is the red,

http://www.installdr.com/Harnesses/Toyota-Wiring.pdf

hakester
08-16-2005, 11:03 AM
read the pinout diagram on the adapter plug (assuming you used one), if you threw it away, the top right pin on the stereo is the yellow wire, next to the left is the red,

http://www.installdr.com/Harnesses/Toyota-Wiring.pdf


Thanks I'll give that a shot tonight!!

Eztrog88
08-16-2005, 11:58 AM
There is usually a way to manually remove the CD. Look for one of those tiny annoying sunk-in buttons that you need a fricken needle to push... if not, take a close look all around the unit.. I'm almost positive there is a manual override.

absolut taco
08-16-2005, 02:55 PM
I just replaced my Stock stereo, after the install I was looking for my new Cd and realized I left it in the stocker, Any Idea how to get it out? taking the new one out is not an option. If I new which pins on the back are power and ground I could probally get it.
That's funny, I did the same. I looked all over for a manual eject option but couldn't find it. Luckily, it was a Genesis CD, so I just said "fuck it!"