I'm looking to get manual hub gear off my tacoma into a different set of spindles. I've been trying to find this in the service manual but so far I've only found stuff relating to the hub body. Anyone have these pages/an expanded view/instructions. I could have sworn that there was instructions regarding the press work. Thanks!
You need a special tool to remove the brass locknut then press out the hub from the spindle with a huge press. It will almost certainly grenade the bearing when you do it.
this was exactly what I needed. Thanks ShowStop. Seeing as how you're in SoCal. Can you recommend a good shop rebuilding the spindles. I don't have access to a press so I gotta go that route.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
TTORA Forum
2.4M posts
75.5K members
Since 2004
TTORA forum is the best Toyota off-road club around. We are nation wide with chapters in most states. Come in and discuss Tacoma, 4Runner, Highlander, & TRD models.