PDA

View Full Version : elocker interchange

tufftoy
02-06-2007, 09:52 AM
will an elocker third member from an 06 fit an older housing? i have a 99 and looking for a spare :confused:
Kaistie
02-06-2007, 11:39 AM
If you hold off I will have a complete TRD locked axle from drum to drum available here pretty soon. If you are interested drop me a PM. I just replaced all the seal and bearings about three months ago. 5.29 gearing.
tufftoy
02-06-2007, 04:15 PM
ive got an entire assembly out of a 99 in my 93. i was wondering if a 06 third would work if it were to go bad.
RadRyan(Fabwerx)
02-06-2007, 06:19 PM
How much are you going to be asking. Ive got a bud that might be interested.
tacoray4x4
02-06-2007, 08:57 PM
Hey man. I would be interested in the rear axle, but not sure when I will have any money and how much wider is it than the factory straight front axle? My front is 55-1/8", the taco rear is either 58" or 60." Hell at least I know the wheel bearings and seals would be good!
Kaistie
02-07-2007, 06:06 AM
Hey man. I would be interested in the rear axle, but not sure when I will have any money and how much wider is it than the factory straight front axle? My front is 55-1/8", the taco rear is either 58" or 60." Hell at least I know the wheel bearings and seals would be good!


Hehehehe, yeah that's true. I am not sure of the width. I am sure someone here knows for certain and can chime in. Worst case you could run a spacer up front to fix the difference. I am not sure if you believe in spacers or not, but I have been running them for well over a year now without any problems at all.
grumpy
02-07-2007, 07:53 AM
Hey man. I would be interested in the rear axle, but not sure when I will have any money and how much wider is it than the factory straight front axle? My front is 55-1/8", the taco rear is either 58" or 60." Hell at least I know the wheel bearings and seals would be good!

Ray if Nate sells his I'll have mine for sale soon too. I think wms is 58. BTW I have tose 1 1/4 " spacers if you get nates rear :eek:
tacoray4x4
02-07-2007, 11:30 PM
I already have 1.5" spacers on the front, but really don't want to go much further. The scrub radius gets too large for easy steering and the whole wheel bearing issues. But I did hear you can get ifs hubs which are wider? I don't know. When you do replace that axle, let me know how much you want for it.