PDA

View Full Version : Lots of Ford stuff...


YotaJosh
10-01-2007, 08:58 PM
Well, I've held onto my Ford stuff long enough. I'm a Toyota dude now, and I need parts. All of this stuff is located in Bismarck, AR, unless otherwise listed. All prices are negotiable.

1. 1977 F100 Truck. Wrecked on driver side. Cab is no good. Frame is straight. Pass. door and fender near perfect. Still has all running gear. 302 V8 with 3 Speed on the column. 8.8 Inch rearend with 2.72 gears. Had a head job and complete top end rebuild 1000 miles before the wreck. Ran and drove around the yard fine when parked (except rag joint separated on steering shaft). Has complete aftermarket A/C that worked fine w/ York compressor. Bed is rusted, but fixable with parts from LMC Truck. I do have all the lenses, trim, some interior, etc. $400.

2. 1968 390 c.i. engine and C6 auto trans. This combo was pulled from a 1968 Galaxie 4 Door. I wanted to keep the motor, but scrap the car. It ran ok when pulled. It needed a bunch of new gaskets, and a decent head job, but the lower end was perfect. Had lots of power as it was. Transmission shifted fine, and didn't seem burnt. May separate if enough interest. $200. SOLD

3. 351 Windsor OEM iron heads. One has valves removed, but I have them. Perfect heads for a 347 stroker built. $50.

4. Edelbrock 600 cfm 4 barrel carb. No choke. Has a tuning kit that comes with it. $50. SOLD

5. Kicker Solobaric 10" subwoofer. Older round design. Barely used. No box. Located in Little Rock. $50. SOLD

Thanks for looking, and tell your friends :D

Arky Tacoma
10-01-2007, 09:45 PM
5. Kicker Solobaric 10" subwoofer. Older round design. Barely used. No box. Located in Little Rock. $50.


I call dibs on the subwoofer!:xozzy:

YotaJosh
10-02-2007, 08:00 AM
5. Kicker Solobaric 10" subwoofer. Older round design. Barely used. No box. Located in Little Rock. $50.


I call dibs on the subwoofer!:xozzy:

Dibs you have.

YotaJosh
10-04-2007, 11:15 AM
:bump:

79coyotefrg
12-29-2009, 10:22 AM
still have this stuff ??

YotaJosh
12-29-2009, 10:54 AM
still have this stuff ??

Just the truck and the 351W heads. The 390, carb, and subwoofer are gone.

I edited the first post.

79coyotefrg
12-29-2009, 11:08 AM
my son in law needs a motor for his 80 F100, it was a 300 6 banger but i guess any ford motor would go in :dunno:

YotaJosh
12-29-2009, 12:11 PM
my son in law needs a motor for his 80 F100, it was a 300 6 banger but i guess any ford motor would go in :dunno:

300 to 302 swap is quite common, but I know nothing about it. I think the transmission bellhousing pattern is the same, so he could use the same trans. Also, I think you need to swap out the frame side motor mounts.

I'm sure I could get it running again with a few hours work if needed.

79coyotefrg
12-29-2009, 12:32 PM
his frame is tweaked just behind the pass side motor mount so he might be better off swapping his body to that frame, :dunno: i'll see what he thinks and get back with ya soon