need bunches guys any ideas will help!

[travise5]

hey everyone new here to the forum and owning a toyota.. mostly a ford diesel man but picked up my 82 model for under a grand so couldnt say no.... so heres the bad lol i was having trouble finding some parts for it as its needed some work since i bought it,
heres what im looking if anyone can hep thatd be great.

both rear tail lights
morker bulb covers for front
plastic cover for steering wheel column
reallllllyyyy need a beddd baddd lmao not much left there
front end bumper and such

thats bout all that really needs fixing at the moment going to be replacing the seats sooner or later somone switched it over to bucket seats that dont work well... but thanks for any help in advance and let me know your ideas! - travis

[LIVES4CRAWLIN]

Low range Offroad should have most everything as far as lighting goes , front
Bumper i would say go ahead and look at a reputable aftermarket replacement and if the be is as bad as you say it is maybe swapping to a flat bed would
Be best but then again I think there's a couple of fiberglass companies that u may be able
To get bed sides from, steering column plastics id just give up on lol

[travise5]

Well far as light they seem expensive for as old as the dern truck is I was hoping to find them cheaper than 70 bucks a price. And I'm just going to search and search for a bed ive never been big on flats beds, just not my thing. Unfortunately the one Toyota bed style I like is the worst one for rusting lol. So off to the junk yards I go I spose hopefully I'll find something there. Anyone know if the early Datsun beds with the rolled edge will bolt up or would I have to modify it

[4banger4x4]

Originally Posted by travise5

Well far as light they seem expensive for as old as the dern truck is I was hoping to find them cheaper than 70 bucks a price. And I'm just going to search and search for a bed ive never been big on flats beds, just not my thing. Unfortunately the one Toyota bed style I like is the worst one for rusting lol. So off to the junk yards I go I spose hopefully I'll find something there. Anyone know if the early Datsun beds with the rolled edge will bolt up or would I have to modify it

no other bed will bolt up but i guess you could pull one you like and chop out the center to get the right width and bob it to get the right length. and then drill some holes to mount.

this is all assuming you can weld