TTORA Forum banner

rear spring help

1K views 2 replies 2 participants last post by  thehackman15 
#1 · (Edited)
hey i just installed a set of procomp lift springs in the back of my 96 tacoma. the springs are so damn stiff that i have the entire thing weighed down with almost a full load of rocks and the front end is still raked down. i adjusted my front sway aways to show 2inches of thread on the bottom hoping that it would help with the rake but it didnt. i think the back is lifted so high that its pushing the front into the ground. is this possible? any suggestions. thanks
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top