TTORA Forum banner

Lets Talk Bumpstops

3K views 4 replies 4 participants last post by  99TanTaco 
#1 ·
#2 ·
The stops I used are from trailgear and I just welded them to the spring plate. Looking back, I should have welded some studs and used nuts to hold them on, but oh well. I have not moved them yet. I was thinking of just extending the plate forward and adding another brace, but I have been less than motivated lately. If I were you I would just box in around the original bump stop mount making it extend forward and then go down from that.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top