TTORA Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
147 Posts
Discussion Starter · #1 ·
just purchased my allied motorsports 4" spindles....and don't want to wait till mon. to get them installed. my only question is...

will I need new bearings and will they need to be pressed out like the 4wd?
 

·
Registered
Joined
·
449 Posts
spindles are $1050 with brake lines. I am going to use dakars since they lift the shit out of the rear, but I also have donahoes up front so I need the extra lift in the rear. You are going to have trouble leveling it unless you go with a deaver 12 pack, dakars, or custom alcans. My truck the way it sits now is 2 inches lower in the rear with 1.5 inch blocks back there and that is with 1/3 of inch of thread showing on the donahoes. I am waiting to get my tires to see if I can lower it any. I am going to sag them as low as possible to maintain tire clearance. I was running them all the way down for a day or so and my god they ride nice.
 
1 - 4 of 4 Posts
Top