TTORA Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
I have an 05 Tacoma reg. cab with the bucket seats and a console. I don't like the high console and want to take out the back half. Does anyone know how this is done. I know how to take out the cupholders and can see the two screws there but I can't see whats holding down the rear part. I want to fabricate another lower console that will alow me to store small items. Any help would be great.

Thanks
Rich
 

·
Old Timer
Joined
·
266 Posts
richd44 said:
I have an 05 Tacoma reg. cab with the bucket seats and a console. I don't like the high console and want to take out the back half. Does anyone know how this is done. I know how to take out the cupholders and can see the two screws there but I can't see whats holding down the rear part. I want to fabricate another lower console that will alow me to store small items. Any help would be great.

Thanks
Rich
I'm not sure on the newer Tacomas but there should be some screws either on the sides next to the seats or in the bottom of the console...
 
1 - 2 of 2 Posts
Top