TTORA Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
516 Posts
I am just finishing up my 231 swap and test fit my 16" Pro Comp 1059's and so far so good. I will report back if they don't fit. But so far they look like they are going to clear just fine. They actually came off my Landcrusher.
 

·
Registered
Joined
·
516 Posts
Well, when I say "just finishing up..." I really mean it's on the back burner and has been for some time. I d/d the Landcrusher, so there hasn't been a huge push to get it done. But I will report back. I did have to ditch the backing plates on the front brakes. They were hitting on the new rotors.
 

·
Registered
Joined
·
516 Posts
Can't you just bend them a little so they clear?
Yeah, I bent them a little, then decided that they didn't really need to be there in the first place. So I took them off. I ditched them on my '84 also with the Trail Gear backing plate eliminator kit and had no issues in doing so.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top