TTORA Forum banner

1 - 14 of 14 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter #1 (Edited)
1993 Solid Axle W/ E-lockers - Ga ** $5,500 FOR JUST THE TRUCK

* 1993 Standard Cab Pick-up - Red - W/ Solid Axle Conversion
* Flat Bed
* Marlin Crawler Transfer Cases ( 2.28 x 2.28)
* Bud Built Skid Plates
* 2" Drive Train Lift By 4-crawler
* 2" Body Lift
* Flexalite Electric Fan
* Custom Alcan Springs In The Rear
* Rancho 4404 Springs In The Front
* 36 X 12.50 X 15 Tsl Radial ( 80% + Thread )
* 5 - Custom Do-it-yourself Bead Lock Kits ( Not Yet Installed )
* Custom Front Bumper W/ Set Of Hela Lights
* Custom Front Axle: 5.29 High Pinion E-locker, 4-crawler High Clearance Skid Plate, Profield Burfields, Vented Disc Brake Conv., And 1.25" Wheel Spacers
* Nissan Pulsar Bucket Seats
* Cobra C-b Radio ( Not Yet Installed )
* Working A/c
* Re-built Engine - Less Than 15,000 Miles
* 5.29 Trd Elocker W/ High Clearance Skid Plate
* Front Shock Hoops
* Custom Rear Shock Hoops
* High Lift Jack
* Lots Of Spare Parts!!!!!!!!!!!!!1

On The Side:

* Miller 175 - 240 Volt Welder And Cutting Torch
* Co-2 Tank W/ High Pressure Regulator
* 3- Personal Holox Refillable Gas Cylinders

Everything Must Go!!!!!!!!!! $ 10,000 / Obo

Can E-mail Pics If Needed.
 

·
Registered
Joined
·
787 Posts
Can I get some pics of the truck? Please send to Lou_Rasta at hotmail.com. I'm only interested in the truck. When are you looking to sell?
 

·
Registered
Joined
·
10 Posts
Discussion Starter #6
The Bead Lock Kits Are Simular To Longs, But They Are "homemade". I Was Hoping To Sell Everything As A Package, But I Will Keep You In Mind If That Doen't Seem Like It Going To Happen.
 

·
Premium Member
Joined
·
800 Posts
JAMES THOMPSON said:
* Marlin Crawler Transfer Cases ( 2.7 X 2.7 )
Are you sure about those ratios?
 

·
Registered
Joined
·
50 Posts
I am interested in you high lift jack and your front bumper. I can understand if you dont want to take off the bumper, but if your runnin short on cash let me take it off your hands.

I am interested to see some pictures, I know a buddy who wants a truck like this real bad. [email protected]
 

·
Registered
Joined
·
10 Posts
Discussion Starter #13 (Edited)
I Am Not Looking To Trade And I Would Like To Sell The Truck And Everything As A Package. I Would Be Willing To Take $7,500.00 For The Truck And All The Spare Parts, Without The welder, cutting tourch, gas cylinders. OBO
 
1 - 14 of 14 Posts
About this Discussion
13 Replies
8 Participants
JAMES THOMPSON
TTORA Forum
TTORA forum is the best Toyota off-road club around. We are nation wide with chapters in most states. Come in and discuss Tacoma, 4Runner, Highlander, & TRD models.
Full Forum Listing
Top