6" fabtech travel
1 - 4 of 4 Posts
Joined
·
787 Posts
From what I understand it keeps the stock geometry. Pretty sure it is mostly going to get you more room for bigger tires. A few guys have trimmed the bump stops some to aid for more flex. Chris should see this and he can answere in more depth.
The fabtech lift does not add any travel. Actually unless you trim the bumpstops it limits uptravel. I have also trimed my bumpstops and the travel is definitely better now. Chris has a great pic of how he trimmed them and the amount of travel he now has. it is pretty goo fr IFS.02taco4x4 said:
1 - 4 of 4 Posts
Join the discussion
Recommended Reading
-
2004 shakes while stopped in drive
Early Tacoma TechHey its me again! So my junk vibrates like a coin operated hotel bed in vegas while im at a stoplight in D. Its smooth in neutral or if i up the idle a bit with my foot on the brake. The motor mounts are great The tranny mounts are great Jst installed new plugs & wires Cleaned and Sea foamed...- 3
- 207
-
SBS · updated
-
Driving with almost no engine oil...apparently possible
Early Tacoma TechA neighbor asked for motor oil for her 01 4Runner. Her dipstick was bone dry and had burnt oil caked on it, as a daily driver who knows how long it's been that low. It took about 3 quarts to get within the marks. Started the engine, rechecked the level, even with all that fresh oil it's dirty. I...- 2
- 177
-
98 Tacoma Mystery Problems
Early Tacoma TechMy truck seems to have a problem with the throttle at 2300 RPMs or below. If I accelerate slowly it bogs and sometimes will "pop". If I stomp on the throttle it runs fine. Background: I had a rebuilt 2.7 motor installed in my 98 Tacoma Excab. The original gave out at 538k miles. While...- 3
- 479
-
99 pre runner ujoint
Early Tacoma TechI have a 99 pre runner ext cab. need to replace ujoint, at trans, and center support. What is the correct moog or spicer part number?? Rockauto has like 4 different ones Thanks- 1
- 127
-
99 Single Cab - Cab Swap done.
Early Tacoma TechIt was only a matter of time until I would need a new cab. Especially doing what we do without a cage. Memorial day I flopped the truck at Katemcy2. After we got it back on all 4s I pulled the plugs and turned the engine over. Topped off all fluids, put the full doors back on and drove home...- 2
- 418
-
Scuba · updated
Join now to ask and comment!