aftermarket fanbelts

1491 Views 4 Replies 4 Participants Last post by bill, Feb 12, 2005

bill

Discussion Starter · Feb 12, 2005

After 70000 miles I am getting around to changing my belts and would like to know a good aftermarket belt or should I go with the OME?Also is there a way to get the correct tension with out a tool? I have heard to tight will wear out bearings etc.
thanks Bill
01 Tacoma v6 sliders trans cooer
Joshua Tree Cal

Save

1 - 1 of 5 Posts

bb609

· #2 · Feb 12, 2005

I think belts are pretty generic. After thirty years of tightening them by feel, I bought a tension gauge just recently. They're not so expensive and now I know they're not too tight. And yes, overtightening could cause failures.

Save

1 - 1 of 5 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.