[2004ej]

I did the quick alarm mod fromCustom Taco's site, however I can't seem to find the place to hook up an LED. I purchased a 12V LED from the RShack and would like to wire it in so "I" remember that the alarm is armed. I am posting on this site because I just seem to like TTORA better . If anyone could help with a pic or some really good idea to where this plug with the four wires is located it sure would help me out, BTY my Taco is a 2004 Ext cab. Thanks.

 

[RENEGADE76254]

i know this post is old but i want to know about that free alarm mod so
bump!

 

[flatlandtacoma]

i know this post is old but i want to know about that free alarm mod so
bump!

It's for 03-04 Tacomas with the factory keyless entry: http://www.customtacos.com/tech/index.php?page=index_v2&id=12&c=6

 

[SandyUT]

on an '04 the plug for the led and GBS is right under the ash tray (the instruction on custom tacos is for other years and the wires are different on the '04). if you take off the deal with the outlets on it, its back there easy to find.

I picked up an OEM GBS and indicator off ebay for $85. It rocks!!! worth every penny. They are on there all the time.

 

[2004ej]

What color are the wires, I plan on adding an led lamp from R'Shack. I ve got an 12volt led and would like to know which wires to hook it up to, thanks for your reply.

 

[SandyUT]

I dont rememeber...I bought the OEM light and sensor and just plugged it in and closed it up. Sorry cant be more helpful.

The connector is obvious though - its the only one there that is not being used (if that is what you mean).

 

[2004ej]

Thanks for the help. Once I figure it out I'll post my results.

 

[HootsMagoon]

Here is the alarm module on eBay $74.99.

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&rd=1&item=7952908020&category=33721

It took me 5 minutes to install it on my 2004. Plus it has a glass breakage sensor. With just the cheap mod all you get is the door lock monitor.

 

[SandyUT]

Hey HootsMagoon - I bought the same one from the same person off ebay. Great deal!!! Great seller too - real fast shipping.

This mod is so much better with the OEM sensor and LED. Worth every penny!!!

 

[steveva]

04 tacoma 5spd

I tried to find the wire in the picture but on mine it looks diffrent.. has anyone done this on an 04?? thanks

 

[kamaaina1]

Which wire are you looking for? If it's the wire to activate the alarm, on my 04 TRD Xcab, I found it just the the left of the steering wheel shaft, just above/near the vent duct. Just disconnect the connector and your set.
If it's the GBS/sensor wire, it's right below the ash tray, behind the aux 12v power outlets taped to a bundle of wires. You can't miss it, it's a four pin connector. But it is a bitch to get to, but it's there. I shelled out the $179 for the factory sensor just to be safe, also, could not find one availabe on ebay.
Good Luck!

 

[steveva]

thanks!!!.. I finally found it.. I was looking too low in the wiring harness