Another New Member says hello
1 - 5 of 5 Posts
Joined
·
3,442 Posts
Hello
Welcome to the group. For more local (Az) info, check out the AzTTORA site. We also can be found on the Southwest board listed on the drop down above. We have a pretty diverse group and enjoy meeting new people.AZ05Taco said:
1 - 5 of 5 Posts
Join the discussion
Recommended Reading
-
Loud ping noise in rear driveshaft
Early Tacoma TechI was active on this forum 10 years ago when my Taco was new. I posted this on the newbie forum and did a search and could not find any info-but I know I am not the only one to have seen this. I have a 2000 taco ext. cab TRD 5 spd 4WD. It has the rear end locker, anti-lock brakes and auto hubs...- 25
- 15K
-
5VZ-FE (3.4L) Lifespan
Early Tacoma TechThe 2.4/2.7L Toyota engines are known for their extreme longevity, and there are even some reports on here of 3.0L V6's pushing over 250k. After hitting 150k today in my truck, I am curious how much longer other 3.4L's have gone without being rebuilt. I drive the shit out of my truck, about 3k...- 245
- 149K
-
2000 Tacoma Suspension, Tire & Wheel Upgrade... 285/75R17 too big with 3" lift
Early Tacoma TechI'm the original owner of a 2000 V6 4x4. It's got 170K mi and has lived a mostly easy life. I installed a 3" RevTek spacer lift kit in 2003 (mistake) and have had issues with tire wear and rough ride since. All these years alignment and tire shops were telling me it was all right but it wasn't...- 3
- 103
-
hooyahdvr · updated
-
Idler pulley bearing
Early Tacoma TechAnyone know what the idler pulley bearing # is, ie 6201 or 6301 for a 3.4L? I replaced it at 150K miles with a rear hub bearing from a motorcycle shop but didn't write in my log what it was. Even better if you can tell me what bike rear hub is the same, I remember the bike shop required a bike...- 0
- 46
-
98 TRD v6, troubleshooting intermittent stumble
Early Tacoma TechI have a 98 V6 Tacoma, that has a frequent but intermittent stumble at mid RPM and part throttle. No CEL or stored codes, coil packs are original, plugs and wires were replaced in summer of 2018. It did seem one of the plug wires was not firmly staying connected to the coil, and I thought that...- 8
- 439
Join now to ask and comment!