I cut the wire on the factory connector about 6 inchs back from the plug so if I ever neded to go back to stock there would be plenty of wire to splice back in. I used wire splices to connect the turn signals then used sealant to keep moisture from getting into the splices.
ARB Guard install - signal lights
Hi all,
Finally got my ARB guard installed... not really too hard but the instructions were simply awful.
One thing was a bit unexpected... For some reason I thought that the bumper mounted signal lights would come with a plug and play adapter to connect to the factory plug/harness (at least mine didn't come with it).
For those of you who have done the install, did you come up with a clean or creative way to connect the lights? I don't really want to cut off the factory plug harness.
Thanks!
Pete
Finally got my ARB guard installed... not really too hard but the instructions were simply awful.
One thing was a bit unexpected... For some reason I thought that the bumper mounted signal lights would come with a plug and play adapter to connect to the factory plug/harness (at least mine didn't come with it).
For those of you who have done the install, did you come up with a clean or creative way to connect the lights? I don't really want to cut off the factory plug harness.
Thanks!
Pete
1 - 1 of 13 Posts
1 - 1 of 13 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
TTORA Forum
TTORA forum is the best Toyota off-road club around. We are nation wide with chapters in most states. Come in and discuss Tacoma, 4Runner, Highlander, & TRD models.
Full Forum Listing
Recommended Communities
