TTORA Forum banner

1 - 20 of 25 Posts

·
Registered
Joined
·
1,866 Posts
Discussion Starter #1
Well I finally got to pull the trans and replace the clutch, I think I will throw some plate on the passenger motor mount since I have room to get to it now.





It's a Faux X 4 bearing that is made in Korea! (it says FAG my camera sucks!)





 

·
Registered
Joined
·
1,049 Posts
When are you gonna come do an act for me? jsut playin, but it looks good so far
 

·
Registered
Joined
·
1,866 Posts
Discussion Starter #12
LOL there wasn't one. I need to break the clutch in a little more before that. But I almost backed into my cabinets in the garage. I started it and was seeing how the clutch felt and tried to let it out slow to see if it engaged and it squawked the tires and almost went into the house!


OOOOPPPPPPPPPSSSSSSSSS.
 

·
Registered
Joined
·
1,866 Posts
Discussion Starter #16
TBob said:
I'll have to try it out - I'll need to put one in once my blower is installed :D
wha wha what?!?!?!

Nice bob! let me know if you need help installing or wiring it.

Carlos has a sweet Dyno guy. $250 flat rate to tune it on a load dyno. I have an appointment on 3-5-07 to tune mine.
 

·
Registered
Joined
·
6,892 Posts
good once u get yours dialed in perfect you can just set mine :D

TimF said:
wha wha what?!?!?!

Nice bob! let me know if you need help installing or wiring it.

Carlos has a sweet Dyno guy. $250 flat rate to tune it on a load dyno. I have an appointment on 3-5-07 to tune mine.
 
1 - 20 of 25 Posts
About this Discussion
24 Replies
4 Participants
TimF
TTORA Forum
TTORA forum is the best Toyota off-road club around. We are nation wide with chapters in most states. Come in and discuss Tacoma, 4Runner, Highlander, & TRD models.
Full Forum Listing
Top