[BigJon]

Does anyone have a write up on how you installed it? I have my in, sort of, I have the green light, but can't get it to give me a signal. I have tried all the out's and have messed with the jumper things. I cut the green wire and ran the wire closest to the tcase to the signal in then ran another wire to the other end of the cut wire and placed it in to out 3 with the jumper 3 on, just like the instructions said to. Well at this point I try and start the cal, I have a steady green light but when I roll I get a flashing green. According to the trouble shooting I'm in the wrong out #. I shut the truck off and swithched it to the next one. Same thing solid green to flashing when moving. So again, shut her down and moved it. I have done it to all the outs and have gotten the same thing everytime with no speed reading. Any insight would be great. The unit I have is a SGI-5B.

 

[EnolaGaia]

Just for the record.... Have you checked the PDF manuals available at Dakota Digital's Tech Support page....

http://www.dakotadigital.com/support.cfm

??... I notice they have 3 different ones listed for the SGI-5 series. Could it be that your instructions are out of date???... Just a thought...

 

[ShowStop]

Does anyone have a write up on how you installed it? I have my in, sort of, I have the green light, but can't get it to give me a signal. I have tried all the out's and have messed with the jumper things. I cut the green wire and ran the wire closest to the tcase to the signal in then ran another wire to the other end of the cut wire and placed it in to out 3 with the jumper 3 on, just like the instructions said to. Well at this point I try and start the cal, I have a steady green light but when I roll I get a flashing green. According to the trouble shooting I'm in the wrong out #. I shut the truck off and swithched it to the next one. Same thing solid green to flashing when moving. So again, shut her down and moved it. I have done it to all the outs and have gotten the same thing everytime with no speed reading. Any insight would be great. The unit I have is a SGI-5B.

Here's a bit of light reading for ya:

http://128.83.80.200/taco/speedo.html
http://128.83.80.200/taco/dakdig.html

 

[BigJon]

Ok got it going. Took some major fiddling to get it all worked out. The directions, for me, made little sense. I the key is knowing what how far you are off. From that point its not to bad, just finding which out to goto and which jumper to have set on or off.

 

[soundstudio315]

Ok got it going. Took some major fiddling to get it all worked out. The directions, for me, made little sense. I the key is knowing what how far you are off. From that point its not to bad, just finding which out to goto and which jumper to have set on or off.

how about some pics of the gauges?
Been thinking about gettins some Digital gauges myself.