TTORA Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
60 Posts
Discussion Starter #1
Has anyone here done it? I was looking at my airbox and am now wondering where a 4" deckplate would fit. Anyone have pictures? Maybe I should just go with removing the elbow....?
Thanks
 

·
Registered
Joined
·
60 Posts
Discussion Starter #3
Oh, many thanks! I'm kinda new here, so forgive me if I'm a little slow...
 

·
Premium Member
Joined
·
8,407 Posts
Maxwell said:
Has anyone here done it? I was looking at my airbox and am now wondering where a 4" deckplate would fit. Anyone have pictures? Maybe I should just go with removing the elbow....?
Thanks
yeah its a little more difficult since the 2.7's airbox isnt flat on any side. i just cut out a complete side since i never mess around in deep stuff.
 

·
Registered
Joined
·
41 Posts
Well i dunno if i would go and cut the whole side off... thats pretty perminante... I did the deckplate with the 4 cyl and the only difference is you can put enough sealant to cover the gaps or you can just not seal it... but its still a lot more protection with the plate in and not sealed then the whole side cut off... i would not suggest this...
brian
 

·
Registered
Joined
·
178 Posts
i removed the elbow connecting it to the fenderwell ... nice thing about that is its not permanent and i can just pop it back in.
 
1 - 6 of 6 Posts
Top