Difference in Manual hubs?

1178 Views 5 Replies 4 Participants Last post by boophoenix, Mar 18, 2005

tenntaco

Discussion Starter · Mar 17, 2005

I went to a salvage yard the other day to get a new hub. They had one truck that seemed to be a 98-00 model. I couldn't really tell cause most of the body was gone. I went to pull the hub, and instead of a snap ring on the end of the cv, there was a brass 12m bolt and washer. I know the ADD cv's have the large bolt on the outer portion, but I'd never seen anything like this on a manual setup. I went ahead and took the hub since nothing really looked different on that end. Has anybody ran into this?

Save

1 - 1 of 6 Posts

grillmasterp

· #2 · Mar 17, 2005

tenntaco said:
I went to a salvage yard the other day to get a new hub. They had one truck that seemed to be a 98-00 model. I couldn't really tell cause most of the body was gone. I went to pull the hub, and instead of a snap ring on the end of the cv, there was a brass 12m bolt and washer. I know the ADD cv's have the large bolt on the outer portion, but I'd never seen anything like this on a manual setup. I went ahead and took the hub since nothing really looked different on that end. Has anybody ran into this?

THe CV shafts should have both a groove for the snap ring AND should have a threaded hole to accept the bolt & washer-
I've seen both on various year Tacomas-

Also- I think the Aisn hubs were redesigned after 96/97 -
Even though they are interchangeable- there was a slight difference in the inner hub- the older one consisted of more parts whereas the newer ones are a solid chunk.
I can post some pics of my collection of manula hub & hub parts

Save

1 - 1 of 6 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month