TTORA Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
2,568 Posts
Discussion Starter #1
Eastwood tube bender with 5 dies, found one for 300. "bought it new for 500, used 2 times".. I low balled him for 250 just to see if he would do it.. he said no at first. then a week later he says yes.. should I get it or no.. I keep looking at the 60˚ angles... Using it for sliders and bumpers. No cage work. Maybe even headers.
 

·
Registered
Joined
·
379 Posts
I was convinced i didnt need an expensive bender and got the "affordable tubing bender" which is pretty much the same bender as that one. I wish i just got a pro tools. These little benders are just a pain to bend a full stick and then kink on thinner walled tube. Ive made 3 bumpers and 2 sets of sliders and since day 1 I have regretted not spending the extra money.

A protools bender mount to bend vertically would be my ideal setup.:2cents:
 
1 - 4 of 4 Posts
Top