TTORA Forum banner

1 - 10 of 10 Posts

·
Registered
Joined
·
2,080 Posts
Discussion Starter #1
Been working on this for the last week or so...







It uses an 8 ton air over hydraulic ram to do the grunt work. It works pretty good. The arms ar 3/4" so it should be able to bend pretty much whatever we need. The tube in it in the pics is 1-3/4" .1875ish wall DOM.

You can also spot the beginning of one of the next major mods to the truck, first person to spot it gets a dollar.
 

·
Registered
Joined
·
271 Posts
I see a transfer case on the bottom shelf of that workbench in the middle pic...are you going dual cases perhaps? BTW, very nice work on the bender I thought it was store bought, but then I see where you painted it.
 

·
Registered
Joined
·
8,499 Posts
that is bad ass! i like it.


btw your next mod is an on-board shop vac! lol
 

·
Registered
Joined
·
2,347 Posts
You next mod i to do anything that will make you go faster than that 15 MPH sign permits!!! :rofl:
 
1 - 10 of 10 Posts
About this Discussion
9 Replies
7 Participants
91toyota4x4
TTORA Forum
TTORA forum is the best Toyota off-road club around. We are nation wide with chapters in most states. Come in and discuss Tacoma, 4Runner, Highlander, & TRD models.
Full Forum Listing
Top