after i read this i went to check out my axles and see if they had this mod done to them and they both have a cap over the tip of the breather. im guessing this is so water dont get in it but is still should be able to breath right. do i need to do the breather mod for my axles or is there anything wrong with having them capped off
Front Diff Breather Mod
I am doing the breather valve mod in the front of my 4Runner. I was wondering if the heat would melt the lines or not.
1 - 1 of 14 Posts
1 - 1 of 14 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
TTORA Forum
TTORA forum is the best Toyota off-road club around. We are nation wide with chapters in most states. Come in and discuss Tacoma, 4Runner, Highlander, & TRD models.
Full Forum Listing
Recommended Communities
