TTORA Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
602 Posts
Discussion Starter #1
Hey, I have a Can-Back on my truck now and was wondering if anybody has rigged any lights to theirs? Whats the best way to run the wires up there without them hanging all over the place (and therefore getting hung up on something)?
 

·
Registered
Joined
·
61 Posts
Use wire loom to wrap the wires, then wrap the whole wire loom in electrical tape. The whole setup can then be ziptied to the frame. I have used this setup on two light bars and have never had a problem. It protects the wires and is quite simple to repair if needed.
 

·
Registered
Joined
·
602 Posts
Discussion Starter #3
That sounds like a pretty good idea. Any ideas on how to mount the lights? Not really in the mood to drop $100+ on a light bar, anybody fab anything up?
 
1 - 3 of 3 Posts
About this Discussion
2 Replies
2 Participants
Ol' Scott
TTORA Forum
TTORA forum is the best Toyota off-road club around. We are nation wide with chapters in most states. Come in and discuss Tacoma, 4Runner, Highlander, & TRD models.
Full Forum Listing
Top