TTORA Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
26 Posts
Discussion Starter · #7 ·
DakotaTacoma said:
Are there any graphs so we can determine what 'real world' HP would be.
I don't know about you, but I rarely, if ever rev up to 4,800 to 5,200 RPM....
So the 160 for the new engine and 150 for the old are not real in my-oh-so- humble-opinion :)
In my case the engine will see red line constantly<if needed>. Charts / graphs would be great to see where peak HP / torque are. This helps in gearing and set up. Big #'s at 4800 and 3600 are nice. I have a dyno chart for a SC motor, but mine will have to be non-SC'd
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top