TTORA Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
52 Posts
Discussion Starter #1
ok i just bought some manual hubs abd want to change the inner boots b4 i put them on my rig, the y are from a taco with stock manual hubs, if that matters, also where is a good place to buy inner boots and how much am i looking 2 spend??? is the install straightfoward?? cut the old boots off and put new ones on??? thanks guys!!!
Chris
 

·
Registered
Joined
·
67 Posts
yota18 said:
ok i just bought some manual hubs abd want to change the inner boots b4 i put them on my rig, the y are from a taco with stock manual hubs, if that matters, also where is a good place to buy inner boots and how much am i looking 2 spend??? is the install straightfoward?? cut the old boots off and put new ones on??? thanks guys!!!
Chris
You can get the boots from the dealer or one of this board's sponsors. You can get the whole boot kit (04438-04021 ) with inner and outer boots, grease, and new clips for about $10-$15 more than inner only kits.

There's a writeup on http://www.ttora-ne.com for cv boot replacement.
 
1 - 2 of 2 Posts
Top