TTORA Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
189 Posts
Discussion Starter #1
Help me out here guys? I've come across an e-locked rear 3rd member from a '98 4-runner for $500 (includes everything) and an e-locker housing w/ axle shafts from an '06 TRD Tacoma for around $75. My question is will this 3rd fit into the '06 housing without any modifications? And if so is the '06 the same width as the rear axle on my '99? Any insight you fellas could give me is greatly appreciated!
 

·
Bear's Chauffeur
Joined
·
2,240 Posts
huh good question. I would think the 3rd would go in the housing just fine. And I am pretty sure that the 05-07 rear axles are wider than the 95-04, but how much I don't know. But that is just a guess from me but if you have both I would bolt them up and see.
But I hope somebody can answer your question better.
 

·
Registered
Joined
·
646 Posts
I was wondering the same thing when I saw that housing and shafts on Ebay yesterday. The newer trucks have a wider WMS so I stopped researching there.
 
1 - 3 of 3 Posts
About this Discussion
2 Replies
3 Participants
ThePinkTaco
TTORA Forum
TTORA forum is the best Toyota off-road club around. We are nation wide with chapters in most states. Come in and discuss Tacoma, 4Runner, Highlander, & TRD models.
Full Forum Listing
Top