I found the tacoma K&N exhaust on NWOR's clearance page for about $260, and couldn't resist that price for a stainless unit.
It arrived today, and looks pretty good- as good as the Borla on my Jeep, if not a little better.
The can has a slight 'z' bend on the inside pipe (think of a stretched out Z), and you can see through the muffler (straight through design).
Out the door cost was about $295 shipped, with CC surcharge. My other chice was an aluminized Gibson, but it would have cost me only 20 bucks less.
Does anyone here run this exhaust, or will I be the first? I figured if I hated the muffler, I could swap in a magnaflow and get a full stainless setup for cheap still.
-Dave
It arrived today, and looks pretty good- as good as the Borla on my Jeep, if not a little better.
The can has a slight 'z' bend on the inside pipe (think of a stretched out Z), and you can see through the muffler (straight through design).
Out the door cost was about $295 shipped, with CC surcharge. My other chice was an aluminized Gibson, but it would have cost me only 20 bucks less.
Does anyone here run this exhaust, or will I be the first? I figured if I hated the muffler, I could swap in a magnaflow and get a full stainless setup for cheap still.
-Dave