Yeah, they have been making them for a couple years now. I don't know who makes them for them, but they used to be pretty pricey. But $260 for a stainless setup is a STEAL.
K&N exhaust any good?
I found the tacoma K&N exhaust on NWOR's clearance page for about $260, and couldn't resist that price for a stainless unit.
It arrived today, and looks pretty good- as good as the Borla on my Jeep, if not a little better.
The can has a slight 'z' bend on the inside pipe (think of a stretched out Z), and you can see through the muffler (straight through design).
Out the door cost was about $295 shipped, with CC surcharge. My other chice was an aluminized Gibson, but it would have cost me only 20 bucks less.
Does anyone here run this exhaust, or will I be the first? I figured if I hated the muffler, I could swap in a magnaflow and get a full stainless setup for cheap still.
-Dave
It arrived today, and looks pretty good- as good as the Borla on my Jeep, if not a little better.
The can has a slight 'z' bend on the inside pipe (think of a stretched out Z), and you can see through the muffler (straight through design).
Out the door cost was about $295 shipped, with CC surcharge. My other chice was an aluminized Gibson, but it would have cost me only 20 bucks less.
Does anyone here run this exhaust, or will I be the first? I figured if I hated the muffler, I could swap in a magnaflow and get a full stainless setup for cheap still.
-Dave
1 - 1 of 10 Posts
1 - 1 of 10 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
TTORA Forum
TTORA forum is the best Toyota off-road club around. We are nation wide with chapters in most states. Come in and discuss Tacoma, 4Runner, Highlander, & TRD models.
Full Forum Listing
Recommended Communities
