TTORA Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
295 Posts
Discussion Starter #1
I took it apart, drilled/tapped it for hydro assist. It leaks out of the top plate (sector shaft plate), I don't see HOW it could seal anyways, there is a groove in the box right where the o-ring seats (towards the steering wheel) that would let fluid past the o-ring and out the top. I have taken it apart and re-assembled it twice. The o-ring looks good so that is all I can think it would be. A rebuild kit from Toyota is $75 ($125 retail), and I am not paying that for a o-ring.

Anywhere I can get an o-ring, or is it another problem? If this keeps going on I might just JB weld the top down on it... (joking)

Thanks
 
1 - 2 of 2 Posts
About this Discussion
1 Reply
2 Participants
Guapotaco
TTORA Forum
TTORA forum is the best Toyota off-road club around. We are nation wide with chapters in most states. Come in and discuss Tacoma, 4Runner, Highlander, & TRD models.
Full Forum Listing
Top