TTORA Forum banner

1 - 5 of 5 Posts

·
Mr. President
Joined
·
1,254 Posts
The stops I used are from trailgear and I just welded them to the spring plate. Looking back, I should have welded some studs and used nuts to hold them on, but oh well. I have not moved them yet. I was thinking of just extending the plate forward and adding another brace, but I have been less than motivated lately. If I were you I would just box in around the original bump stop mount making it extend forward and then go down from that.
 

·
Registered
Joined
·
3,646 Posts
Discussion Starter #5
The stops I used are from trailgear and I just welded them to the spring plate. Looking back, I should have welded some studs and used nuts to hold them on, but oh well. I have not moved them yet. I was thinking of just extending the plate forward and adding another brace, but I have been less than motivated lately. If I were you I would just box in around the original bump stop mount making it extend forward and then go down from that.
thanks, I'll prob make that my next project after I finish the bed
 
1 - 5 of 5 Posts
Top