TTORA Forum banner

Metal Cutting

  • Plasma

    Votes: 7 70.0%
  • Band Saw Vert or Horiz

    Votes: 3 30.0%
  • Abrasion Chop Saw

    Votes: 0 0.0%

  • Total voters
    10
  • Poll closed .
1 - 9 of 9 Posts

·
Registered
Joined
·
3,984 Posts
Discussion Starter #1 (Edited)
I like Polls...

Okay, which would you rather have?

Plasma
Band saw
Chop saw

Each have their own +/- including cost and ancillary equipment required to operate...

EDIT: General home/shop use for fabrication of raw materials and vehicle modifications.
 

·
Registered
Joined
·
8,499 Posts
angle grinder.




if not that then plasma.
 

·
Registered
Joined
·
3,984 Posts
Discussion Starter #6
EDIT: General home/shop use for fabrication of raw materials and vehicle modifications.

....or combination of tools. Hand grinder is a given.
 

·
Registered
Joined
·
2,612 Posts
Plasma
Band saw
4 1/2" angle grinder with a cut off wheel is good too.
I would use a rusty pocket knife before a chop saw anymore.
 
1 - 9 of 9 Posts
About this Discussion
8 Replies
7 Participants
crawlrunner
TTORA Forum
TTORA forum is the best Toyota off-road club around. We are nation wide with chapters in most states. Come in and discuss Tacoma, 4Runner, Highlander, & TRD models.
Full Forum Listing
Top