TTORA Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
169 Posts
Discussion Starter #1
Does anyone have a T100 drill guide for a 3.4? To borrow or buy!

Pics for click bait!





Sent from my iPhone using Tapatalk
 

·
NorCal Chapter Pres
Joined
·
12,202 Posts
Fwiw, i just cut my dipstick. About 1/8" below the full mark and it still bottoms out on the housing

Sent from my SM-G920V using Tapatalk
 

·
Registered
Joined
·
169 Posts
Discussion Starter #4
No drill guide but if you're drilling a 3.4 there is a boss in the block casting for the dipstick.


It's a 2003 so there's no knock-out plug. By Boss I assume that's the same thing. :shrug:


Sent from my iPhone using Tapatalk
 

·
Premium Member
Joined
·
12,929 Posts
No a boss is a pace in the the casting meant to drill out a hole for the dipstick. They may save costs in later model years by not drilling the hole then have to cap it when they don't make the truck model that needs it anymore. However it would cost them to change the tooling used to make the casting in order to eliminate the boss so it will still be there since it costs nothing.
 
1 - 5 of 5 Posts
Top