TTORA Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hey everyone, Just picked up a 97' 4x4 taco with low mileage for cheap.

In the process of doing a full frame fab/replacement and doing a basic SAS swap. Truck is currently not a daily driver so time is not important, just plugging away!

To do list: Finish frame fabrication, install SAS, build flatbed, patch floor, swap EVERTHING to new frame, redo all lines and install fuel cell. (To start :surprise:)

Any tips to a newbie builder would be appreciated! I have basic welding skills and good mechanical aptitude, but this will be the first time doing anything this scale!
 
1 - 2 of 2 Posts
Top