TTORA Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1,001 Posts
Did your instruction sheet give info on mounting?
On the PA 3" when you flip the brackets you have to drill new top mounting holes or the bumper will angle towards the body. Flipping the brackets places the bumper almost to high with a 3" lift, so im not sure how it would work with a 2.5".
Truthfully I didnt know PA sold 2.5" B/L's.
Tim
 

·
Registered
Joined
·
1,001 Posts
Sounds like you'll have to either weld to the frame (wouldnt be my favorite), or make a new bracket. On my 3" the tailgate barely clears the trim on top of the bumper, I could imagine a 2.5" would'nt clear.
Is it possible to take off some of the top of the bumper trim?

Tim
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top