TTORA Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1,472 Posts
Discussion Starter #1 (Edited)
Perfect T fitting for boost gauge, FTC, Ect.

I don't know if its the hardware stores in my area but I had trouble finding a T fitting thats similar to the one thats included in the TRD boost gauge.

I gotta say McMaster Carr rules. This fitting is acutally better because the compression ferrules is attached to fitting itself. All you need is a little teflon tape.

http://www.mcmaster.com

Part number:

4455k159 Brass double-barbed tube fitting tee 1/8
5220k31 Self alinging brass compression tube fitting 1/8

About 7$ total shipped on my doors step in two days.


Edit: FYI Aquamist 2d kit already comes with a plastic T and rubber line.
 

·
Registered
Joined
·
4,295 Posts
thanks for the info...good to know
 

·
Registered
Joined
·
1,216 Posts
Brass fittings are a bit overkill. Simply not needed. Plastic T fittings and silicone hose is more the sufficent.
 

·
Registered
Joined
·
1,472 Posts
Discussion Starter #4
Gadget said:
Brass fittings are a bit overkill. Simply not needed. Plastic T fittings and silicone hose is more the sufficent.

If you use 1/8 OD tubing hardline you should use a compression T. "Overkill" kinda of a relatively term. Its only a few dollars extra. If you think this is overkill then using extreme is also overkill. But whatever floats your boat.
 
1 - 4 of 4 Posts
Top