TTORA Forum banner
1 - 1 of 1 Posts

·
Administrator
95.5 Tacoma
Joined
·
18,720 Posts
Upper ball joint I'm assuming? If so, then thats pretty much it. You really wont need the impact to tighten it down, regular hand tools should do the job just fine. Tighten to within 10 ft/lbs of spec, then turn as needed to line-up the cotter pin hole.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top