TTORA Forum banner
Cancel

Quick help...wiring of apexi

1628 Views 3 Replies 2 Participants Last post by  odonekanobe, 
O
Im trying to wire in my apexi s-afc II into a 2003 tacoma. I was looking at the wiring diagram for the truck, and there is more than one wire coming from the sensors. (AFM, TPS). Does anyone know which wires I should connect the apexi to?

Thanks,

Eric
Reply
Save
Like
1 - 3 of 4 Posts
O
Well that's what we were planning on doing. What I dont know is which wires to tap into. For example, the tps has three wires coming into the ecu. I think that one of the wires is the signal wire, and the other two are power, but how do I know which one to tap into? Same with the afm.

Has anyone on here installed one in a taco? I have evrything run, the wires are at the ecu, just don't know which ones to tap into.

Thanks,

Eric
Reply
Save
Like
O
Has anyone hooked up an apexi? Or have an idea of which wires to tap into?

Eric
Reply
Save
Like
1 - 3 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
TTORA Forum
TTORA forum is the best Toyota off-road club around. We are nation wide with chapters in most states. Come in and discuss Tacoma, 4Runner, Highlander, & TRD models.
Full Forum Listing
Explore Our Forums
Early Tacoma Tech Parts/Electronics/Wheels/Tires Newbie Tech Performance/Engine/Exhaust Tell us who you are
Top