TTORA Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
93 Posts
Discussion Starter #1
I have finished my rear bumper and wanted to show it to you all. The only thing I "farmed out" was the welding of the shackle points. They are 1" thick and my welder is just not powerful enough to insure good penetration on steel that thick. The specs are 2"x5"x3/16" square stock for the bumper and channel stock mounting the bumper to the frame. I was able to use the original holes on the frame and the original bolts. Now I need to put this bumper to work and test it out.....

Brent
 

Attachments

·
Registered
Joined
·
478 Posts
Brent13 said:
I have finished my rear bumper and wanted to show it to you all. The only thing I "farmed out" was the welding of the shackle points. They are 1" thick and my welder is just not powerful enough to insure good penetration on steel that thick. The specs are 2"x5"x3/16" square stock for the bumper and channel stock mounting the bumper to the frame. I was able to use the original holes on the frame and the original bolts. Now I need to put this bumper to work and test it out.....

Brent
Could you send my a pic of the under side(the mount points to the frame
)? [email protected]

Thanks
Eric
 

·
Registered
Joined
·
478 Posts
Firetacoma said:
Looks real good! Like mine was supposed to look! lol
Yeah but didnt yours come off an early Bronco?
 
1 - 7 of 7 Posts
Top