TTORA Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
4,793 Posts
Discussion Starter #1
i bought a set of leaves used from a guy. im planning on using these for my leaf pack rebuild and i bought some poly bushings to redo the leaves with all new. here is my dilemma. the bolt was cut off in the front of both bushings. when trying to turn it with vise grips it turns the whole bushing. i have tried the air hammer and such to get it out. i got the rears out by burning them and popping them apart but ive tried that and it doesn't seem to do much for these front bushings. does anyone have any other ideas? ive also tried my air chisel with little sucess aside from starting to remove the outer sleeve of the bushing. im hoping to get the packs done so that i can put them on my truck sometime next week ....
 
1 - 1 of 1 Posts
About this Discussion
0 Replies
1 Participant
tacotoy
TTORA Forum
TTORA forum is the best Toyota off-road club around. We are nation wide with chapters in most states. Come in and discuss Tacoma, 4Runner, Highlander, & TRD models.
Full Forum Listing
Top