[tnracing132]

Hello

I just bought these saw 2.5 coilovers from camburgfor my tacoma prerunner v6 how do you determine how far down to get say 1.5 " lift, I'd rather ask then do trial/error to save me time.

thank you

Tony

 

[synovus]

Don't worry about saving time. Do it right instead. Trial and error is going to be your best bet, because every truck is different. It's not a matter of a certain number of turns on the adjustment collar, or the amount of threads showing. Take a ride height measurement before you do anything (stock measurement), then measure again after you've installed the SAW's. At that point, you should have about 2" of lift. Then take the wheel(s) off again, crank the SAWs down a little, re-install wheel, and remeasure. Repeat as necessary until desired ride height is attained.

 

[x0ffr0adtac0x]

also remember the threads on the c/os will be off from one another. driver side might have more threads showing b/c of battery, gas tank, driver

 

[tobsilent]

A measurement taken after removal of jack stands will be taller then after a test drive. Keep that in mind. It took me a few times to get it where I wanted it.