TTORA Forum banner
1 - 11 of 11 Posts

· Registered
Joined
·
42 Posts
Discussion Starter · #1 ·
Anyone know what size allen wrench the set screw on the Donahoe Coilover's is? Maybe a 5/32?
 

· Registered
Joined
·
42 Posts
Discussion Starter · #3 ·
Nope, not yet. I actually just received the coilovers today. I was taking a look at them and just wanted to check what it was, in case I need to adjust them when I put them on.
 

· Chicks Dig Body Damage
Joined
·
548 Posts
wtwnsnd said:
Nope, not yet. I actually just received the coilovers today. I was taking a look at them and just wanted to check what it was, in case I need to adjust them when I put them on.
Did you install them yet. I have some on the way. Let me know how it goes.

Jason
 

· Registered
Joined
·
382 Posts
Yea, thats the size. They took me about 30 minutes to put on. Really easy. From the factroy it comes set at two inch lift, i cranked mine to 2.25 inches fromt the top of the shock to the spring mount. You can see my results here
 

· Registered
Joined
·
192 Posts
Chas said:
Yea, thats the size. They took me about 30 minutes to put on. Really easy. From the factroy it comes set at two inch lift, i cranked mine to 2.25 inches fromt the top of the shock to the spring mount. You can see my results here
An additional 1/4" likely gave you a lot more then a 1/4" more ride height. It looks like you've got a lot of lift, good thing that's a prerunner. :)

I gave a my collars a few turns one time just to see how quickly I would start gaining more lift and even with just a few turns I got around 1/2 an inch after settling. I backed them off to maintain down travel as well as to prolong the life of my CV boots.
 

· Registered
Joined
·
42 Posts
Discussion Starter · #10 ·
jbstrd said:
Did you install them yet. I have some on the way. Let me know how it goes.

Jason
Haven't installed them yet. Probably won't get to for another week or so.
 
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top