Their exhaust bolts, and probably all rusted too. You wouldnt want to put those back on anyways. Just take a sawsall to the bolt and cut it off. Then go get some new ones for 2 bucks at home depot. Faster and youll be better off in the long run.hezy said:
Stock cat-back bolt removal problem
I can not get the two bolts unscrewed off the cat/long pre muffler pipe. I tried spraying it with WD-40 and waitng and no luck. I tried putting a pipe on the end of the handle of the socket wrench for more torque and nothing. This sucks. I bought a magnaflow cat-back to install and can not do anything about it. My truck is only 8 months old and those bolts are all rusted to shit. Did the Michigan winter rust the underside of my truck that bad? Any helplful ideas would be appreciated.
1 - 1 of 9 Posts
1 - 1 of 9 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
TTORA Forum
TTORA forum is the best Toyota off-road club around. We are nation wide with chapters in most states. Come in and discuss Tacoma, 4Runner, Highlander, & TRD models.
Full Forum Listing
Recommended Communities
