TTORA Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
6,892 Posts
Discussion Starter · #1 · (Edited)
made from 3/8" plate with factory bump stops welded on - super beefy



Lacation - my garage
First $40 takes em
 

·
Premium Member
Joined
·
3,569 Posts
demello - but i've found out since that that isn't where the frame is bending.
Your frame is bending? Didn't know that.....where at and what do you think it's from?

The reason for my questions is I am considering a new high clearance rear bumper with spare tire swing out - any thoughts/suggestions?
 

·
Registered
Joined
·
6,892 Posts
Discussion Starter · #6 ·
It doesn't hurt to run the demello plates - I have seen pics of guys frames that were bending there - mine was slightly and I thought thats where the problem was totaly but in doing my Chevy swap I found the bending was more on the inside of the frame between the cab and the bed. So I would recomend plating that area too.
 
1 - 7 of 7 Posts
Top