[Hutch98]

Is there a particular part # for the Chevy TRE's people are using in there set up's?

Thanks again

Hutch

 

[TMS2U]

Check out Parts Mike

Off of the top of my head, I think that the Pass side TR link that the DL hooks up to is 2233L

 

[dyogim]

I oppted to have the drag-link attach to the pass. arm instead of the tie rod. I used 2010L for the pass. side of the tierod.

 

[Davidtaco]

I use ES2027L and ES2026R for both the tie rod and drag ling... my drag link also mounts to the steering arm.

http://www.partsmikeparts.com/tre_comparison.htm

-David

 

[Crash]

I use ES2027L and ES2026R for both the tie rod and drag ling... my drag link also mounts to the steering arm.

http://www.partsmikeparts.com/tre_comparison.htm

-David

David, What is the part number for the steering arm so I can mount the draglink to the arm?

 

[cb77DEMELLO]

Is there a particular part # for the Chevy TRE's people are using in there set up's?

Thanks again

Hutch

I second parts mike!

 

[Hutch98]

Ordered from Parts Mike last night. Thanks again for the info

Hutch

 

[BlingTaco]

I use ES2027L and ES2026R for both the tie rod and drag ling... my drag link also mounts to the steering arm.

http://www.partsmikeparts.com/tre_comparison.htm

-David

Hey David,

I'm currently running 2010's on driver side and tie rods ends are welded on the passenger side.........i'm switching mine up, going with parts mike stuff, and was going to do just the 2026 and 2027 for both drag and tie rod for simplicity...for 2 reasons: to make it easier (cheaper) to replace passenger side TRE's but also, it sounds like you can get 60 degrees movement on the 2026 and 2027 where you can only get 20 to 30 degrees out of the others......do you agree.......any problems with your setup, how long have you had it like that.........I go through TRE's like crazy and your setup is exactly what I was going to order.....tell me tell me