TTORA Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
2,047 Posts
Discussion Starter · #1 ·
So searching didnt work.
My ujoints are shot, I found grease where they sprayed on the underside of my truck while putting on my train horn. I also found out my carrier bearing is shot.
I went ahead and ordered the carrier bearing, it will be in today, and I have my U joints in my truck.
Is this a do it yourself type of project with tools and a decent to ok vise? Or should I pay someone to do this?

Also, I found some write up online but I had no idea if it was a toyota or not.

Thanks
Benson
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top