TTORA Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
215 Posts
Discussion Starter #1
I lost this gasket and ordered a replacement part 90430-37140 but the part seems too thick. The oil filler cap will only catch a few threads with the gasket on and I'm afraid I'll lose the cap. Ran it a while with no gasket - not a good idea, oil leaks out.

I re-checked the part number with some online dealers, appears to be correct.

I tried slicing it in half but it's too tough. I'll try ordering another, perhaps I got the wrong part and I don't have the original packaging so not sure I got the above part number although receipt says i did.

Anyone have this issue?

Thanks
 

·
Registered
Joined
·
215 Posts
Discussion Starter #2
Never mind, old seal still in the cap, was hard as plastic so I did not realize.
 

·
Registered
Joined
·
91 Posts
Ha! I had the exact same thoughts when I went to replace mine. Amazing how hard that rubber gasket became. Sure nice to not be leaking oil there now.
 
1 - 3 of 3 Posts
Top