TTORA Forum banner

1 - 20 of 26 Posts

·
Registered
Joined
·
1,479 Posts
Discussion Starter #1 (Edited)
Its been in my garage for the last 4 years on the shelf since I removed it off my Taco.

I guess I'm not going to use it....... :(

All it needs is a roller fairlead.

$500.00 firm







702-596-8185
Jeff
 

·
Registered
Joined
·
1,832 Posts
Thought you were going to swap this on your 85?
 

·
Registered
Joined
·
1,479 Posts
Discussion Starter #13
i live up north and i get off work at 3. Text me your address. 714-887-6893.


Here is the info told you about.


88 Toyota Pickup
-22RE-installed with approx 50,000 miles I will check the receipt I have, motor runs very strong
-Stock Trans and transfer case, shifts and runds great
-SAS done by Vorfab
-Trail Gear front shackle hangers
-AllPro crossover steering
-Steel braided brakelines
-Front 4" lift springs
-Marlin Crawler assembled front 3rd member, 5.29 with Lockright
-5.29 V6 Rear 3rd member welded
-Stock rear springs with 3" block
-34-10.50-15 Super Swamper LTB
-Harbor Freight 8000# winch
-beginning of a bumper started, currently just a winch plate and winch installed
-Old school Smittybuilt rear bumper

Built the truck in 2007 then the military stationed me in Korea. Wheeled it a couple times now and then and moved to Italy after Korea. Then stationed in Las Vegas, drove it the 8-10 hrs from Twin Falls to Las Vegas without a problem in the summer heat. Essentially the new front and rear 3rd members are near new, motor is barely broke in for a 22re and the Clutch was replaced with the motor. All has been wheeled a hand full of times. The only reason I give this truck up is that it doesn't have 4 seats.

I have wheeled the Oyhees and many other local Idaho trails flawlessly. Meatgrinder, 2HD, Twin Falls Canyon. It has some nicks and dings but still has good body panels.

I will update and add pics soon.

Truck is located in Las Vegas but can deliver to south Idaho with some assistance. email me for questions [email protected]

$3500
 

·
Registered
Joined
·
1,479 Posts
Discussion Starter #15
It's Not looking good. Fixing my drive shaft is going to eat up Jan. discretionary income.:( Have fun though.
That sucks. I know how expensive driveshafts can be.. Id recommend Adams for the work. let me know if anything changes.. :)
 

·
Registered
Joined
·
505 Posts
Its been in my garage for the last 4 years on the shelf since I removed it off my Taco.

I guess I'm not going to use it....... :(

All it needs is a roller fairlead.

$500.00 firm

702-596-8185
Jeff
Jeff I will take it if still available.
 
1 - 20 of 26 Posts
Top