TTORA Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter #1
I am about ready to put my Bilstein 5100 preloads in the frontend for a 2 inch lift and 5100 shocks in the rear. Then I am going to get new wheels and put BFGS A/T 285s on the truck. I have a 2006 4 door 4x4 TRD off road Tacoma. How much triming of the wheel wells do I have to do ? And where on the wheel wells do I have to do this triming? Allso is possible to transfer the tire pressure sensor to any after market wheels out thier or do I face the same problems everyone else has talked about on this board? Thanks in advance
 

·
Registered
Joined
·
43 Posts
I was able to switch my pressure sensors without any problems; alloy 16's to alloy 16s. As far as trimming, you shouldn't need to trim anything other than the front inner wheel well, nothing that is painted. When you put tires on you'll see what needs to be removed.
 
1 - 2 of 2 Posts
Top